Appearance Floor Finish

Appearance® is a new generation floor finish that achieves maximum performance when maintained by spray buffing and/or high speed buffing. This versatile product provides outstanding response to a variety of equipment/speed/pad combinations to produce excellent results.

Superior resistance to scuffing, scratching, and marking. Spray buffing will clean, repair and improve the beauty of the floor.

9631 – 4/1 Gallon
9635 – 1/4 Pail
96355 – 1/55 Drum

Use Information

Appearance® Floor Finish is recommended for use in spray buffing or high speed buffing maintenance programs, on all resilient flooring, tile, terrazzo and clay tile. Not recommended for use on wood floors.

Product Specifications

pH – 8.6 ± 0.4

Appearance – Off-White Emulsion

Fragrance – Acrylic

Freezing Point – About 32°F

% Non-Volatile Solids – 18.5

% Solids – 23.5

Boiling Point – 212°F

Solubility in Water – Dispersible

Flash Point – None

Coverage – 1800 – 2200 sq. ft. per gallon (may vary due to the porosity of the surface).

Directions for Use

Initial Application:

1. Remove old sealer/finish using a Fullpro stripper and following label directions.

2. Apply a thin coat of Appearance® using a clean finish mop.

3. Allow 20-30 minutes drying time.

4. Apply 4 coats for best results allowing for adequate drying time between each coat.

Maintenance:

1. Dust mop, damp mop or sweep regularly. Use a neutral cleaner, such as Concur™.

2. For best results, allow Appearance® to cure for 24 hours before buffing.

3. Spray buff as needed using a high-speed machine and appropriate pad.

Note: Clean and recoat areas as the foundation becomes thin or as buffing response decreases.

Ingredients

Water – 7732-18-5

Styrene acrylate polymer – 25085-34-1

Diethylene glycol monoethyl ether – 111-90-0

Ethylene copolymer – 67892-91-5

Tri-butoxyethyl phosphate – 78-51-3

Styrene acrylic copolymer – Mixture

Related Products

View All Floor Care Products