Super Gard Undercoater/Sealer

Super Gard™ represents a ‘modern concept’ in acrylized emulsion polymer chemistry. It is a major breakthrough in reference to the total undercoater/sealer protection of all resilient and non-resilient floors, with the exception of unsealed wood floors. Super Gard™ is formulated with metalized acrylic polymers, thereby achieving exceptional levels of durability and protection. Super Gard™ is an excellent choice where protection from salt exposure is required.

F316026 – 1/5 pail
F136038 – 1/55 drum

Use Information

Super Gard™ is recommended for use on vinyl composition, vinyl asbestos, vinyl, asphalt, linoleum and rubber floors. May be used on non-resilient surfaces that are not glazed. These surfaces include concrete, terrazzo, quarry tile, Mexican tile, brick, marble, slate and other non-resilient floors.

Product Specifications

pH – 8.8 ± 0.5

Appearance – White Emulsion

Fragrance – Polymeric

Freezing Point About 32°F

% Total Solids – 21.1

% Non-Volatile Solids – 16.3

Boiling Point – 212°F

Solubility in Water – Complete

Flash Point – None

Coverage – 1700 to 2000 sq. ft. per gallon (may vary due to differences in porosity of the surface)

Directions for Use

Initial Application:

1. Remove old sealer or finish using a Franklin stripper and following label directions.

2. Apply one or two coats of Super Gard™ using a clean finish mop and a bucket.

3.  For best results allow adequate drying time between each coat.

4. Apply 2-3 additional coats of a Franklin floor finish. For best results allow adequate drying time between each coat.


1. Dust mop the floor. Remove gum, labels and other attached soils with a long-handled scraper or putty knife.

2. Damp mop or autoscrub using a Franklin cleaner, following the label directions.


Water – 7732-18-5

Acrylatecopolymer – 28263-96-9

Ethylene glycol – 107-21-1

Diethylene glycol monoethyl ether – 111-90-0

Tri butoxyethyl phosphate – 78-51-3

Related Products

View All Floor Care Products