Dimension Floor Finish

Dimension™ is an advanced technology floor coating specially formulated with our patented APTTM Polymer System. Dimension™ will provide exceptional durability, repairability and a beautiful wet look gloss. Dimension™ allows facilities currently burnishing 5-7 times per week to reduce to 3-4 times per week when used according to directions with the recommended system components.

F330225 – 1/5 cube
F330238 – 1/55 drum

Use Information

For use on vinyl composition, vinyl, asphalt, sealed concrete, terrazzo and sealed wood.

Product Specifications

pH – 8.3 ± 0.4

Appearance – Off White Emulsion

Freezing Point – About 32°F

% Total Solids – 24.0

% Non-Volatile Solids – 18.5

Boiling Point – 212°F

Flash Point – None

Coverage – up to 3000 sq. ft. per gallon (may vary due to differences in porosity of the surface)

Directions for Use

Initial Application:

1. Remove old sealer/finish using a Franklin stripper and following label directions. Before coating an old or porous floor use 2 coats of Super Gard to seal the floor.

2. Apply a thin coat of Dimension™ using a clean Fuller Brush Finish Mop.

3.  Allow 20 minutes drying time.

4. Apply a total of 4-6 thin coats allowing adequate drying time between each coat.

5. Burnish: Optional – following last coat after minimum 1 hour dry time.

Maintenance:

1. Dust Mop the floor several times daily. Remove gum, labels, and other attached soil deposits with a long-handled scraper or putty knife.

2. Damp mop or autoscrub daily using UHS Combo Cleaner/Maintainer and following the label directions.

3. Burnish the floor 3-4 times per week with a high-speed speed machine (>2000RPM) using an appropriate pad. If the floor begins to look worn, a scrub & re-coat after 6-8 weeks will decrease the need for frequent stripping.

Ingredients

Water – 7732-18-5

NJ TSRN – 100555-5009

Dipropylene glycol methyl ether – 34590-94-8

Diethylene glycol ethyl ether – 111-90-0

Tributoxyethyl phosphate – 78-51-3

Related Products

View All Floor Care Products