Carb & Choke Cleaner
Carb & Choke Cleaner is a special formulation that removes harmful carbon, gum, varnish and other deposits produced by internal combustion engines. For use on carburetors, automatic chokes, fuel injectors, PCV valves and lines, manifold heat control valves and other sticking parts caused bygasoline byproducts. Carb & Choke Cleaner is catalytic converter and oxygen sensor safe.
F765015 – 12/15 oz.
For use on carburetors, automatic chokes, fuel injectors, PCV valves & lines, and other sticky parts caused by fuel byproduct buildup.
pH – N/A
Appearance – Clear, Thin Liquid
Fragrance – Solvent
Freezing Point – About 32°F
Solubility in Water – Insoluble
Physical State – Liquid Under Pressure
Warehouse Storage – (NFPA) Level 3 Aerosol
Flash Point – No data available
Directions for Use
Shake can well before use. Attach the extension tube to nozzle button. Turn the engine off. Remove air cleaner and spray exposed parts liberally, including carburetor throat and linkage. Open choke manually and spray both ends of choke valve. Adjust air-fuel mixture and start engine. Spray vacuum cylinder with the engine running. Turn engine off and disconnect crankcase side of PCV valve. Insert extension tube and spray, moving rube from side to side. Allow to soak for 2-3 minutes, then start the engine to flush valve and repeat. Spray exposed end of the heater valve shaft. Wait for full penetration and move counterweight up and down to free operation.
Acetone – 67-64-1
Toluene – 108-88-3
Methyl Alcohol – 64-56-1
Carbon Dioxide – 124-38-9